Search found 55 matches
- Tue Mar 22, 2016 12:36 am
- Forum: Technical - Engines and Boilers
- Topic: Olfelt
- Replies: 68
- Views: 66495
Re: Olfelt
Yeah I thought it would be too complex, ok back to drilling rp
- Sun Mar 20, 2016 9:28 pm
- Forum: Technical - Engines and Boilers
- Topic: Olfelt
- Replies: 68
- Views: 66495
Olfelt
OK, I'm in the throes of building an Olfelt to replace my old Semple, a LOT of coiling! Now in the process of drilling the centre pipe BUT before I go any farther, I've been thinkin' ( BAD idea) As anyone tried a water wall around the firebox ( on an Olfelt type)? Simple coils of pipe would work fin...
- Sun Mar 20, 2016 9:15 pm
- Forum: Technical - non Engines and Boilers
- Topic: Swift Lubricator
- Replies: 4
- Views: 7854
Re: Swift Lubricator
Yes I did try one for a season and it did work fine BUT it's hard to really turn down the oil flow to not get too much into the hotwell. I've removed it and have a manual oiler valve assembly on the top of the HP cylinder, IF I hear any groaning out of the motor (mostly at lower speeds) I give it a ...
- Fri Mar 18, 2016 5:32 pm
- Forum: Technical - Engines and Boilers
- Topic: Primary leads or lags secondary?
- Replies: 14
- Views: 13178
Re: Primary leads or lags secondary?
I use a whistle valve on mine, mounted on the receiver with a pipe to HP steam chest, just hit the lever and off it goes. BUT this only works when the engine is up to temp, if too cool hydrolocking is a possiblity! No it doesn't matter about backpressure on HP, you don't run it simpled just bump it ...
- Fri Mar 11, 2016 8:35 pm
- Forum: Technical - Engines and Boilers
- Topic: 12v feed pump?
- Replies: 45
- Views: 34921
Re: 12v feed pump?
I too am using a hypro, chain driven to the prop shaft, the pump is quiet but you do hear a little chain noise even though it's mounted under the floor board. It is bolted to the cabin wall and I think that amplifies it.. I've also got an injector (1/2in Penberthy) which CAN fill the boiler in a hur...