Cylinder machining

A special section just for steam engines and boilers, as without these you may as well fit a sail.
Post Reply
User avatar
Lopez Mike
Full Steam Ahead
Full Steam Ahead
Posts: 1758
Joined: Wed Dec 07, 2011 6:41 am
Boat Name: S.L. Folly
Location: Lopez Island, Washington State, USA

Cylinder machining

Post by Lopez Mike » Fri Mar 20, 2020 3:48 am

I cannot find that this series of YouTube videos has been posted to the forum.

A welcome tutorial for those who cannot easily find suitable castings.

https://www.youtube.com/watch?v=vhvVQg19jgs
If you think you are too small to make a difference, try sleeping with a mosquito.
Dalai Lama
User avatar
TahoeSteam
Full Steam Ahead
Full Steam Ahead
Posts: 594
Joined: Fri Mar 07, 2014 5:38 am
Boat Name: Wayward Belle
Location: South Lake Tahoe, CA, USA
Contact:

Re: Cylinder machining

Post by TahoeSteam » Fri Mar 20, 2020 6:54 pm

Mr Crispin has a great series of videos. Thank you for sharing that.
~Wesley Harcourt~
Check out the steamboat and steamSHIP videos on my YouTube page: https://www.youtube.com/c/wesleyharcourtsteamandmore
TriangleTom
Warming the Engine
Warming the Engine
Posts: 89
Joined: Mon Oct 31, 2016 5:57 pm
Boat Name: No Boat Yet
Location: Norman, OK

Re: Cylinder machining

Post by TriangleTom » Sun Mar 22, 2020 3:12 am

Thanks for sharing that!
Post Reply