And Now for the Twin

A special section just for steam engines and boilers, as without these you may as well fit a sail.
Mike Rometer
Full Steam Ahead
Full Steam Ahead
Posts: 843
Joined: Sat Aug 13, 2011 6:41 pm
Boat Name: B.N.Y.S.
Location: Middle Earth

Re: And Now for the Twin

Post by Mike Rometer » Fri Nov 20, 2020 4:40 pm

Little by little!

It's easier to list what's been done than try to show everything,

With all the holes for covers plotted and drilled, they have been tapped.

The covers have had their holes opened out to clearance size.

Gland holes plotted, drilled and tapped along with the exhaust flange holes.

Studs for the glands have been made, and a load of nuts, screws, washers, and bolts have been ordered on-line.

Cyl Glands (10) (600 x 450).jpg
Cyl Glands (10) (600 x 450).jpg (61.73 KiB) Viewed 67 times
Exhaust Flanges (1) (600 x 450).jpg
Exhaust Flanges (1) (600 x 450).jpg (66.86 KiB) Viewed 67 times

Meanwhile I have also found up some nice material for the cross-heads and semi-finalised the design/shape. (Oh yes, and a couple of brews drunk. :lol: )
Retirement is about doing what floats your boat!

A BODGE : - A Bit Of Damn Good Engineering.
Mike Rometer
Full Steam Ahead
Full Steam Ahead
Posts: 843
Joined: Sat Aug 13, 2011 6:41 pm
Boat Name: B.N.Y.S.
Location: Middle Earth

Re: And Now for the Twin

Post by Mike Rometer » Sun Nov 22, 2020 5:37 pm

Another spell in the w'shop today, sees 300 hours broken.

Having started to the cross-head material amongst the many bits the other day, I cut the groove to full depth for the guide and brass slipper.

I then attempted to cut the piece in two with a slitting saw and gave up, far too slow. Finished it in the power hacksaw. Cleaned one end, the other end will do for a tomorrow job, getting kinda stuck 'til I get a delivery.

Cross-heads (5) (600 x 450).jpg
Cross-heads (5) (600 x 450).jpg (61.27 KiB) Viewed 24 times
Retirement is about doing what floats your boat!

A BODGE : - A Bit Of Damn Good Engineering.
Post Reply