Hey guys, water was leaking out of the bottom of my sight glass tricocks yesterday. I decided it was time I remove the packing nuts, the brass packing plug and check the state of the water glass washers. It was clear, it was time to replace them. Just wanted to make sure I reassembled it correctly. I installed one new rubber washer each (top&bottom) on the glass, found new O-rings to go on the top side of the brass packing plugs where they interlock with the packing nuts and re-tightened, by hand, till firm.
Anything I may have over looked?
I plan to get up a small head of steam tomorrow afternoon to confirm all is tight before putting her back in to service on Saturday. Just curious if you felt I forgot anything.
As always, Thanks!
Mack
Check out our Facebook page: https://www.facebook.com/TulePrincessSteamboatCompany
Water glass installation
- Mfoxchicago
- Full Steam Ahead
- Posts: 161
- Joined: Sat Jun 01, 2013 11:59 pm
- Boat Name: PS Tule Princess
- Location: San Angelo, Texas
- Contact:
Water glass installation
Capt. Mack H Fox
TULE PRINCESS STEAMBOAT CO.
Lake Nasworthy, San Angelo, Texas
Follow us as:
Facebook - @Tule Princess
Twitter - @tuleprincess
Website - www.tuleprincess.com
TULE PRINCESS STEAMBOAT CO.
Lake Nasworthy, San Angelo, Texas
Follow us as:
Facebook - @Tule Princess
Twitter - @tuleprincess
Website - www.tuleprincess.com