Been making a lot of videos lately. Here is a video yesterday of the high pressure penberthy steam injector and a little bit of general operation/theory.
Yes I know that this quite an injection of water from a low water level for this boiler. It's hard doing all the tasks and taking a video at the same time.
Demonstrated is a 1/2" High Pressure Penberthy. It's slightly special - most of the AA models floating around, I had to trade for it - it works up to my MAWP of 200PSI.
A special section just for steam engines and boilers, as without these you may as well fit a sail.
1 post • Page 1 of 1