Page 1 of 1
Simpson Strickland engine
Posted: Fri Aug 17, 2018 4:54 pm
by steamboatjack
https://thesteamboatingforum.net/forum/ ... ew&id=1814
picture shows a Simpson Strickland quad "B" size of 1889, this was rebuilt a short time ago, now ready for dispatch.
Regards
Jack
Re: Simpson Strickland engine
Posted: Fri Aug 17, 2018 9:08 pm
by dampfspieler
Hello Jack,
a very nice engine. Can you show some more pics of this engine?
Regards Dietrich
Re: Simpson Strickland engine
Posted: Sat Aug 18, 2018 6:39 pm
by TriangleTom
Absolutely beautiful engine. I didn't know there were any left.
Re: Simpson Strickland engine
Posted: Sun Aug 19, 2018 8:43 am
by steamboatjack
There are a number of the smaller Kingdon engines about in UK, USA and one in NZ mainly of the 1/4A,A & AB sizes, I suspect this is the only B (or larger) engine left and certainly the only one capable of operation.
Regards
Jack
Re: Simpson Strickland engine
Posted: Sun Aug 19, 2018 8:59 am
by TriangleTom
steamboatjack wrote: ↑Sun Aug 19, 2018 8:43 am
There are a number of the smaller Kingdon engines about in UK, USA and one in NZ mainly of the 1/4A,A & AB sizes, I suspect this is the only B (or larger) engine left and certainly the only one capable of operation.
Regards
Jack
I'm not terribly familiar with Simpson Strickland's terminology. Being that this is the B, is this the 14 hp vaiant?
Re: Simpson Strickland engine
Posted: Mon Aug 20, 2018 7:00 am
by steamboatjack
No that is the A size. the B is 28 I.H.P. at 250 P.S.I. and 450 RPM. or 20 I.H.P. at 175P.S.I.
Jack
Re: Simpson Strickland engine
Posted: Fri Aug 31, 2018 5:57 am
by dhic001
steamboatjack wrote: ↑Sun Aug 19, 2018 8:43 am
There are a number of the smaller Kingdon engines about in UK, USA and one in NZ mainly of the 1/4A,A & AB sizes, I suspect this is the only B (or larger) engine left and certainly the only one capable of operation.
Regards
Jack
There are actually two in NZ, both AB sized engines, the one commonly known about in Flirt, and the NZ supplied engine shown on the cover of funnel mag a couple of issues back.
Daniel