My Duplex feed pump design
Posted: Wed Nov 18, 2009 6:45 pm
Posted on behalf of Maltelec:
Maltelec
Site Admin
Joined: 23 Sep 2007
Posts: 156
Location: Cumbria, UK
Posted: Mon Oct 08, 2007 3:51 pm Post subject: My Duplex feed pump design
Here is a picture of my design for a duplex feed pump. Top to bottom it is 500mm. 50mm bore steam, 30mm bore water, 90mm total stroke but it should run with a 70mm stroke as the piston covers up the exhaust ports on the steam cylinder.
_________________
I've got the vehicle , just need the boat.
Last edited by Maltelec on Sat Oct 13, 2007 3:07 pm; edited 2 times in total
Back to top
Maltelec
Site Admin
Joined: 23 Sep 2007
Posts: 156
Location: Cumbria, UK
Posted: Sat Oct 13, 2007 12:42 pm Post subject:
I've finally finnished drawing the pump with all the nuts and bolts and revised the water outlet.
_________________
I've got the vehicle , just need the boat.
Maltelec
Site Admin
Joined: 23 Sep 2007
Posts: 156
Location: Cumbria, UK
Posted: Mon Oct 08, 2007 3:51 pm Post subject: My Duplex feed pump design
Here is a picture of my design for a duplex feed pump. Top to bottom it is 500mm. 50mm bore steam, 30mm bore water, 90mm total stroke but it should run with a 70mm stroke as the piston covers up the exhaust ports on the steam cylinder.
_________________
I've got the vehicle , just need the boat.
Last edited by Maltelec on Sat Oct 13, 2007 3:07 pm; edited 2 times in total
Back to top
Maltelec
Site Admin
Joined: 23 Sep 2007
Posts: 156
Location: Cumbria, UK
Posted: Sat Oct 13, 2007 12:42 pm Post subject:
I've finally finnished drawing the pump with all the nuts and bolts and revised the water outlet.
_________________
I've got the vehicle , just need the boat.