Hi there
New to the forum and recently picked up an engine which I had hoped may be able to run a smaller launch 15’ or so.
It has two 2” cylinders with a stroke about 1.5-1.75”. The head appears to maybe be bronze? With brass pistons?
It’s about 15” tall x 10” wide and 7 deep.
It’s missing a few parts (mostly bolts), and the piping.
My plan is to restore it, polish and clean it up and tidy up any areas that need attention.
Any thoughts on a make/designer would be appreciated. It has a cross head piston attachment for a water pump by the looks of it.
Cheers
Markus
Unknown Engine…
Unknown Engine…
- Attachments
-
- IMG_1415.jpeg (192.28 KiB) Viewed 3596 times
-
- IMG_1414.jpeg (122.46 KiB) Viewed 3596 times
-
Re: Unknown Engine…
Couple more pics
- Attachments
-
-
- IMG_1417.jpeg (142.01 KiB) Viewed 3595 times
-
- IMG_1416.jpeg (121.51 KiB) Viewed 3595 times
Re: Unknown Engine…
More
- Attachments
-
- IMG_1483.jpeg (173.69 KiB) Viewed 3595 times
-
- IMG_5018.jpeg (185.34 KiB) Viewed 3595 times
-
dampfspieler
- Full Steam Ahead
- Posts: 290
- Joined: Wed Nov 18, 2009 6:59 am
- Boat Name: No Boat Yet
- Location: Neubrandenburg, Germany
- Contact:
Re: Unknown Engine…
Hi Markus,
a very interesting engine.
You can built a pump unit with a condensate pump in the middle and a boiler feed pump a the right an a circulating pump at the left side. Or you split it to every crosshead.
I have calculated the dimensions of the boiler feed pump as follows:
Bore 8 mm
Stroke 44 mm
The length of the boat should be a bit longer 17 - 20'.
Best Wishes
Dietrich
a very interesting engine.
You can built a pump unit with a condensate pump in the middle and a boiler feed pump a the right an a circulating pump at the left side. Or you split it to every crosshead.
I have calculated the dimensions of the boiler feed pump as follows:
Bore 8 mm
Stroke 44 mm
The length of the boat should be a bit longer 17 - 20'.
Best Wishes
Dietrich
Re: Unknown Engine…
Thnx!