Elliott Bay triple expansion engine

Maltelec · Post by **Maltelec** » Sun May 01, 2011 12:20 pm

The latest on the 2nd engine.

Aheadslow · Post by **Aheadslow** » Sun May 01, 2011 4:37 pm

Looks like you are well on the way to another beautifully built engine. How well do the EB triples perform ? Looks like they should do well when built properly. Keep up the good work, love the vids.

steamboatjack · Post by **steamboatjack** » Mon May 02, 2011 8:46 am

The first engine has not yet been fitted in the boat, I wish it had so I can get some feed back.
Regards
Jack

DetroiTug · Post by **DetroiTug** » Mon May 02, 2011 4:25 pm

Beautiful engine, very nice work!

-Ron

DetroiTug · Post by **DetroiTug** » Fri May 13, 2011 7:43 pm

Jack,

If you don't mind, what are the overall dimensions of this engine L X W X H??

Mounting dimensions?

I looked on Elliot Bay's site and I did not see it.

Thanks, Ron

steamboatjack · Post by **steamboatjack** » Sun May 15, 2011 12:43 pm

total length 32 ins width about 16 at widest height 27.
Bed plate length 26.5 width 12. Engine bearers need to be 9.75 apart inside and 3.5 vertical needed to clear cranks.
regards
Jack

The Steamboating Forum

Elliott Bay triple expansion engine

Elliott Bay triple expansion engine

Re: Elliott Bay triple expansion engine

Re: Elliott Bay triple expansion engine

Re: Elliott Bay triple expansion engine

Re: Elliott Bay triple expansion engine

Re: Elliott Bay triple expansion engine